Home | Site Map | Cisco How ToNet How To | Wireless |Search | Forums | Services | Donations | Careers | About Us | Contact Us|

EqualLogic: You have elected to cancel the update

Network Sharing , TCP/IP, Internet, Wireless, Exchange, IIS, ISA and Print

EqualLogic: You have elected to cancel the update

Postby blin » Mon Nov 09, 2009 9:29 pm

When tryiing to upgarde the EqualLogic SAN Firmware from 3.3.3 to 4.0.7, I receive this message:

update

This command will update the firmware on the array's flash card memory
using the update kit file that was copied to the array.

If you choose to proceed, you will be shown the current firmware version
and the version to which you will update. You will then be given the
choice to proceed again.

Do you want to proceed (y/n) [y]: y


17:20:03 Updating from kit file "kit_V4.0.7-R94173_4244411.tgz"
17:20:03 Unpacking kit file and verifying integrity.
17:20:08 Kit file verification complete, no problems.
17:20:11 Active and secondary controllers detected.
17:20:12
17:20:12 Currently running version is: Storage Array Firmware V3.3.3 (R7840
4)
17:20:12 You will be updating to version: Storage Array Firmware V4.0.7 (R9417
3)
17:20:12
17:20:13
17:20:13 PLEASE NOTE:
17:20:13
17:20:13 You are upgrading from firmware version V3.3.3 to version V4.0.7.
17:20:13 You will NOT be able to downgrade back to V3.3.3 once the
17:20:13 upgrade is finished.
17:20:13
The firmware update will not take effect until you restart the array.

Do you want to proceed (y/n) [n]: 17:20:13 You have elected to cancel the update
SANGP3> e
How to Configure and Troubleshoot Cisco
http://www.howtocisco.com

Tablet and Smartphone Setup Guide
http://www.quicksetupguide.com
blin
Site Admin
 
Posts: 3643
Joined: Wed Dec 31, 1969 7:00 pm
Location: Chicago, USA

Re: EqualLogic: You have elected to cancel the update

Postby chicagotech » Mon Nov 09, 2009 10:07 pm

This happens when the telnet program sends an extra linefeed after <enter> is hit.

With windows telnet, use the following steps to clear this setting:
^] (control, right bracket)

Welcome to Microsoft Telnet Client
Escape Character is 'CTRL+]'
Microsoft Telnet> unset crlf
Line feed mode - Causes return key to send CR
Microsoft Telnet>
(pressing enter will return you back to telnet)
Microsoft Telnet> o SAN ip address

With Putty, select Connection, telnet, and remove the check mark for "Return key sends telnet New Line instead of ^M"
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
chicagotech
Site Admin
 
Posts: 7084
Joined: Mon Nov 27, 2006 1:24 pm
Location: Chicago USA


Return to Networking

Your Ad Here

Who is online

Users browsing this forum: Google [Bot] and 6 guests