Solved: VPN access issue - System error 53

[chicagotech]

Keith,

Thank you for sharing your experience with us.

Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
"KeithXP" <KeithXP> wrote in message news:15ABAF3E-D0D0-4C76-A36A-F7F5A9641E8B@microsoft.com...
Solved!

In my case it turned out that something must have happened to the VPN
connection between the my two Netgear routers. I completely reset the
router on my home network, and set up the VPN connection from scratch.
All working perfectly now.

Good luck with your issue.

Keith

"KeithXP" wrote:

> Thanks Jim -
> Unfortunately it doesn't appear to apply for my situation. I am not getting
> a message about server storage, but checked the value of the registry
> entry mentioned (IRPStackSize) and it is at the default value of 15.
>
> I thought I might be onto something with the Scope ID for Netbios (which
> must be the same on all computers in communication, it seems). But
> that was a red herring as well.
>
> I also tried removing all the updates installed in April. No change.
>
> I am connecting to my server directly by VPN as a workaround until I
> figure it out. It is very exasperating!
>
> thanks
>
> Keith
>
>
>
> "jamesh@tribcsp.com" wrote:
>
> > I did a bit more searching and found a couple of other references to
> > the exact error we're seeing.
> >
> > In those threads, it was suggested to read
> >
> > http://support.microsoft.com/?scid=kb;en-us;177078
> >
> > which seems to address exactly the error messages we're getting.
> >
> > The error we're getting is similar to the one quoted in one of these
> > threads:
> >
> > "\\Serverprcessor\Mydocuments is not accessible. You might not have
> > permission to use this network resource. Contact the administrator of
> > this
> > server to find out if you have access permissions.
> >
> > Not enough server storage is available to process this command."
> >
> > This may or may not have anything to do with your problem, KeithXP,
> > but I thought I'd mention it here since it does look like it may be
> > the answer to my problem.
> >
> > Here are the threads that I found that reference this:
> >
> > http://groups.google.com/group/microsof ... 1996f92821
> >
> > http://groups.google.com/group/microsof ... 6b3631cc5e
> >
> > Good luck to you, and wish me luck too. This might fix it for me.
> >
> > Thanks everyone.
> >
> > Jim
> >
> >
> >
> >