Home | Site Map | Cisco How ToNet How To | Wireless |Search | Forums | Services | Donations | Careers | About Us | Contact Us|

How to run Windows OS with a clean boot

Active Directory, Domain, DNS, WINS, DHCP, SBS, New Releases.

How to run Windows OS with a clean boot

Postby blin » Wed Dec 06, 2006 6:44 pm

To troubleshooting spyware, virus and other issues when you cannot determine the cause of the issue, you may run Windows Safe Mode or Safe Mode with Network. With MSCONFIG, you also can configure a clean boot to disable common startup programs, settings, and drivers to eliminate possible software conflicts. To perform a clean boot, please follow these steps:

2) In the Services tab, click "Hide All Microsoft Services" and click
"Disable All".
3) In the Startup tab, click "Disable All". Click OK. (This will
temporarily prevent third-party programs from running automatically during

Note: Clean Boot is just a troubleshooting step. If some programs have been
disabled, we can enable them later on. If you see the System Configuration
Utility, check the box of "Don't show this message" and then click OK.

How to return from a Clean Boot state
1. Click "Start"->"Run", type "msconfig" (without the quotation marks) and
press ENTER.
2. On the "General" tab, click "Normal Startup - load all device drivers
and services".
3. Click "OK". Click "Restart" when you are prompted to restart your
How to Configure and Troubleshoot Cisco

Tablet and Smartphone Setup Guide
Site Admin
Posts: 3673
Joined: Wed Dec 31, 1969 7:00 pm
Location: Chicago, USA

Thank to you for the help me!

Postby Spounctut » Tue Dec 25, 2007 7:10 am

Thank to you for the help me!
Now I have no problems

Jon Wens

Posts: 4
Joined: Mon Dec 24, 2007 10:37 pm
Location: Nepal

Return to Windows

Your Ad Here

Who is online

Users browsing this forum: No registered users and 5 guests